Latching Push Button Switch, URTONE UR129, 1NO ON/Off DC/AC 36V 2A Aluminum Alloy Metal Shell Suitable for 12mm 1/2" Mounting Hole (Black)

Needed to add a switch and this worked perfectly for the spot. Fast shipping and well packaged

It was quite a bit smaller than I expected which was perfect cause it made it much easier to install in my car

If you want to avoid soldering the connectors a 2.8 female will work if you crimp is closed just a bit before hand. It requires 1/2" hole to be drilled to accept the body of the switch. I used it to turn on & off my voltmeter that is directly connected to my trolling motor batteries. I connected the 12 volt incoming ground wire to the "negative side" of the switch & put a jumper from the "positive side" of the switch to the negative side of my voltmeter, works perfect !!!

This push button switch is to small for my project. It’s size was shown in Metric which causes me to change into inches, so i must have converted it wrong. Be sure to read size carefully

These are cool, they look better than a light switch and give a modern, even futuristic feel to light management in our travel trailer (I'm VP of Light Management around here, the kids are the primary testers and the wife is, of course, Captain Lightmaster). Anyway, they're cool, if a bit touchy - one in particular doesn't want to "stick" unless you push it in significantly hard.

I used it to turn on and off my LED which I installed in my cabinets.

I used it for my dual mode exhaust on my Corvette, and it works great. Pins are very small, so I soldered mine, I don't think a push in connector would work very well.

great switch for a low voltage/amperage situation.it is just shy of a 1/2" diameter on the threaded portion.i went just shy of 1/2" for my mounting hole.if you go 1/2" and have some chatter in your drill bit, you may not cover the entire hole with the flange.