Gangmu Tec Pack of 8 Universal Aluminum Vehicle Hood Pins - License Plate Lock Clip, Push Button Bonnet, Quick Release Lock Latch Bumper, Diameter 1.25 inch (Black, Pack of 4)

I picked these up to make my front bumper a quick release. I looked at the name brand ones and they were a lot more expensive than these. So I gave these a try and they seem to be just as good as the name brand and work great as a quick release for my front bumper.

Consider this a neutral review.These pins work the way push type pins should work, but if you’re thinking of using them for your car’s hood…maybe get the bigger ones. These look like they should secure the hood of a power wheels…or maybe some small go-cart body panels.They work, yes.They install easily, yes.They’re functional, yes.They’re relatively built well, yes.But they are the size of a US quarter.They definitely are NOT the size you think they are.Put them on your car’s hood if you’re looking to be questioned by your car friends and laughed at.

Look great, good retention. Used to attach my bumper. First set I bought unscrewed from vibrations. The center is barely hand tight. If you use these make sure to either peen over the edges or put lock tight on the middle section

I used this product to hold my front bumper in place. Makes taking off the bumper to do oil changes much quicker. Easy product to adjust once you get pass the anxiety of drilling into your car. I also did the hook with the larger quick pin to keep flex down white on the interstate. I installed the pins first than using some paint in the tip of the pin to mark the bumper to drill the holes.once the pins and buttons are snapped in you can move the nut to adjust to line up the bumper with the fenders. This is the third set and have had no problems with fit or finish.

Love the appearance. Used to fasten panels on my back seat delete for my mustang.

Love the color I got, and they feel well made

My ride is 2004 Acura TL. The TL's are made in Ohio on the same platform as Accords. I hate to say, but unlike the TSX that are made in Japan (called Accord Euro in Japan), the quality control is not on par and there are noticeable gaps between the body & bumpers. The worst section had as much as 1cm of a gap. I needed something to correct the issue without spending $$$ at a body shop.These happen to be the best solution for correcting the issue. On LH & RH side of the rear bumper, I was able to narrow the gap by more than half (there are still gaps, but are a lot less noticeable). I used a Unibit, or step-drill bit to drill holes on the PPP bumper. The key is to make the hole slightly smaller than the collar, so that they fit snugly and the nut & Loctite would make it loosening-free. I installed x3 of these on each side (a total of 6). Like many things, these are made in China but the quality isn't so bad so I gave them a 4-star.

ours lasted a long time on the side by side

fast shipping , have not installed yet but looks good for my app.

They look pretty cool and hold down the hood with no issues whatsoever. Easy install on an E46.

Tried pulling them apart. Positive lock works hope they last

if used for licence plate all 4 are required or the blade can swing. my truck only has a spot for the top 2 screws and after installing the plate had a lot of movement and swing. I had to use 2 polishing disc's from my dremel to stop it. they are just form enough to take up the slack that allows movement but I can still compress them enough to get it locked on. I don't recommend for quick release licence plate unless u can use all 4 on 1 plate

Simple use as required